1. Important product information
Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole
or in part only with our consent.
2. General safety precautions
Risk of electric shock!
230 V means danger to life!
• Disconnect the power supply before attempting
any work on the product.
• During installation, the electric power cable
being connected may not be live. Therefore,
switch off the power first and use a voltage
tester to make sure the wiring is off-circuit.
• Installing the sensor involves work on the
mains power supply. This work must therefore
be carried out professionally in accordance
with national wiring regulations and electrical
operating conditions. (e.g. DE - VDE 0100,
AT - ÖVE / ÖNORM E8001-1, CH - SEV 1000)
• For products with COM2 port: connection
B1, B2 is a switching contact for low-energy
circuits. This must be fuse-protected in line
with the technical specifications.
• Only electronic ballasts with a floating control
signal may be used at the DIM 1 to 10 V
control output.
• No mains voltage may be connected to
control output/input DA+ / DA-.
• Only use genuine replacement parts.
• Repairs may only be made by specialist
workshops.
3. Proper use
The use for which the sensor version is intended
is described in the relevant general operating
instructions.
The general operating instructions can be
opened by using the QR code from the Quick
Start provided.
4. Electrical connection
Important: incorrectly wired connections will
produce a short circuit later on in the product
or fuse box. In this case, you must identify the
individual cables and re-connect them. An
appropriate mains switch for switching ON and
OFF can be installed in the mains lead.
5. Installation
• Check all components for damage.
• Do not use the product if it is damaged.
• When installing the product, make sure the
installation site is not subject to vibration.
• Select an appropriate mounting location,
taking the reach and motion detection into
consideration.
6. Cleaning and Maintenance
The product requires no maintenance.
Hazard from electrical power.
Contact between water and live parts can result
in electrical shock, burns or death.
• Only clean the product in a dry state.
Risk of damage to property!
Using the wrong detergent can damage the
product.
• Clean product with a moist cloth without
detergent.
7. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environmentally
compatible manner.
Do not dispose of electrical and
electronic equipment as domestic
waste.
EU countries only: Under the current European
Directive on Waste Electrical and Electronic
Equipment and its implementation in national
law, electrical and electronic equipment no longer
suitable for use must be collected separately
and recycled in an environmentally compatible
manner.
Significant improvement in detection quality.
Activate and deactivate detection zones and adjust sensor sensitivity.
Install, adjust and network digitally.
